Adaptec AHA-1540B Installationsanleitung

RInstallation GuideAHA-1540CP/1542CPISA-to-SCSI Plug and PlayHigh-Performance Bus Master Host Adapter with SCSISelect Utility

9If you have multiple AHA-1540CP/1542CP host adapters in your computer, use the SCSI Disk Utili-ties to determine which host adapter you are configuri

10SCSISelect. You can stop the test at any time by press-ing Esc. Your PC will reboot.Operating System Software SupportWindows 95Windows 95 has embedd

11Troubleshooting ChecklistIf a problem occurs during installation, check these items first: Are the power cables and SCSI interface cables properly

12Adaptec Customer Support ServicesIf you have questions about installing or using the host adapter, check this install guide first—you will find answ

13FCC Compliance StatementNOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 o

1IntroductionThis Installation Guide explains how to install and configure Adaptec AHATM-1540CP/1542CP Plug and Play ISA-to-SCSI high-performance bus

2Host Adapter LayoutThis diagram shows the major AHA-1540CP/1542CP components. The following table describes each component: 1 AHA-1542CP only.Label D

3Default SettingsThe AHA-1540CP/1542CP operates correctly with the factory default settings in most PCs. Plug and Play may override some settings when

4Installing the Host AdapterFollow these steps to insert the host adapter in a slot:WARNING: Turn OFF and disconnect the power to your PC and attached

56 Attach the host adapter bracket to the PC chassis with the expansion slot cover screw.Note: Do not replace the PC chassis cover or reconnect the po

63 Plug the last connector on the ribbon cable into the connector of the closest internal SCSI device. Maintain pin-1 orientation.4 Plug the middle co

7SCAM cannot change or read the SCSI IDs of some older SCSI devices. If you have any such devices and SCAM is enabled on the host adapter, your PC may

8Reassembling and Starting the PCFollow these steps to reassemble and power the PC:1 Check SCSI cable connections. They may have been loosened if you