Adaptec APA-1480 Bedienungsanleitung PDF herunterladen (Seite 7)

APA-1480 Enabler for DOS Installation 1

C H A P T E R

Installation

The Enabler may be installed either in CONFIG.SYS, AUTOEXEC.BAT or

started from DOS command line. It’s possible to relocate enabler into upper

memory using DEVICEHIGH or INSTALLHIGH statements in CONFIG.SYS.

The Enabler provides several command line switches allowing fine-tuning of

the driver. In more complicate cases you may create an initialization file with

very detailed configuration instructions.

It is recommended that you fine-tune CardBus Enabler switches starting

CardBus Enabler from the command line. After switches are set, you can place

call of CardBus Enabler either to CONFIG.SYS or to AUTOEXEC.BAT.

Deployment

In order to use SCSI devices (such as JAZ drive or CD-ROM) you typically will

need to load APA-1480 Enabler, Adaptec ASPI manager ASPI8DOS.SYS and

driver for your device. E.g. usage of CD-ROM requires ASPICD.SYS; usage of

SCSI Disk – ASPIDISK.SYS, etc. ASPI manager and required drivers could be

found in the Adaptec EZ-SCSI package.

However APA-1480 Enabler may provide support of Adaptec APA-1480

SlimSCSI CardBus cards and SCSI devices without load any additional drivers.

For use CD-ROM you will also need to load MSCDEX.EXE in your

AUTOEXEC.BAT.

If you are trying to use SlimSCSI with IOMEGA JAZ device we recommend

that you be using IOMEGA GUEST.EXE application rather then stack of ASPI

drivers. It gives more compact image on the floppy.

Memory Requirements

APA-1480 Enabler require 4 kB of memory per CardBus socket to establish the

memory access to CardBus registers. This memory is required only during

initialization.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Adaptec APA-1480 Bedienungsanleitung Seite 7