Adaptec 29320-R - SCSI Card RAID Controller Bedienungsanleitung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 5
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
1. Added support for Windows Server 2008
5. Prerequisites of Using the Software:
-------------------------------------------
The driver should be used with the following BIOS and software versions:
Expansion ROM BIOS for 29320A-R, 29320ALP-R, 39320A-R - v4.30.0
Adaptec Storage Manager (ASM) and HRCONF - 5.10.0 Build 17173
6. Tested Configuration:
---------------------------
The software was tested with the Hardware Supported list on the motherboard with
the IBM PC/AT compatible PCIe platforms. These are the various components used
during the testing:
- IBM x86 PC/AT compatible platforms with Intel Xeon
- Tested with direct attached Ultra160 and Ultra320 disk drives, tape devices
and enclosures
7. Known Issues/Limitations:
--------------------------------
1. Issues have been seen with drive ordering during the installation of Windows
Server 2008 when more than one bootable controller is installed in the system.
Microsoft recommends having only one bootable controller active/installed during
the installation of the operating system. Controllers that have the BIOS or
INT13 Support disabled are not causing an issue.
2. Multi-initiator configurations are supported with Ultra160 and previous
generation hard drives. Current generation Ultra320 hard drives do not support
this configuration.
3. An Event 9 in the Event Viewer may occur with a DLT 7000 or 8000 tape device.
If this occurs, install the registry fix (MAXIO64K.REG) located in the Windows
Driver directory.
8. Windows REGISTRY PARAMETERS:
----------------------------------------------
8.1 Driver Specific Registry Parameters
WARNING: Altering or adding these driver parameters incorrectly can render your
system inoperable. Use them with caution.
Follow the instructions below to enter the registry values that affect the
configuration information for Adaptec SCSI Card drivers. All SCSI Cards
supported by the installed driver are affected by the values you enter here.
Seitenansicht 1
1 2 3 4 5

Kommentare zu diesen Handbüchern

Keine Kommentare