Adaptec ACS-100 Bedienungsanleitung PDF herunterladen (Seite 8)

Installing a Disk Drive

Before you begin, ensure that you are installing the proper disk

drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch IDE

hard disk drives only.

Note: You need a Phillips screwdriver to complete this task.

To install a disk drive into your USB Enclosure:

1 Use a screwdriver to remove the two screws on the back of the

enclosure.

2 Remove the enclosure’s back panel, as shown below, and slide

out the disk drive tray.

3 Connect the disk drive tray’s internal power connector and IDE

cable to the disk drive.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Adaptec ACS-100 Bedienungsanleitung Seite 8