Adaptec 29320-R SCSI Card Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Schnittstellenkarten / Adapter Adaptec 29320-R SCSI Card herunter. Adaptec 29320-R SCSI Card Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - INSTALLATION GUIDE

INSTALLATION GUIDEADAPTEC SCSI CARD 29320ASC-29320 IG.fm Page 14 Wednesday, August 14, 2002 2:00 PM

Seite 2 - INTRODUCTION

9Connect the other end of the cable to a SCSI connector on the back of an external device. If you are installing only one external device, terminate t

Seite 3

10The last SCSI device on the end of each SCSI bus cable must be terminated, and termination must be disabled for all other devices in the middle of t

Seite 4 - SETTING UP SCSI DEVICES

11Preloaded Adaptec DriversIf the Adaptec SCSI Card 29320 was included as part of a computer system you purchased, the system already has the appropri

Seite 5 - CONNECTING SCSI DEVICES

12Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

Seite 6 - Nonterminated end

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interf

Seite 7 - Connecting Wide SCSI Devices

1The Adaptec SCSI Card 29320 enables you to connect up to 15 Low Voltage Differential (LVD) and/or 15 Single-Ended (SE) SCSI devices—such as very larg

Seite 8 - SCSI device

2Discharge any static electricity build-up before handling your SCSI card by touching a grounded metal object (like the exposed metal parts on the bac

Seite 9

3Computers may have vertical or horizontal expansion slots. Refer to your computer manual to locate the PCI/PCI-X slots. If your computer is a tower m

Seite 10 - Terminated SCSI device

4Check the SCSI IDsThe Adaptec SCSI Card 29320 and each device you connect to it must have a unique SCSI ID number ranging from 0 to 15 on each channe

Seite 11 - TROUBLESHOOTING

5cables are laminated so that they lay flat. Internal LVD cables usually have a terminator built into the end of the cable.The Adaptec SCSI Card 29320

Seite 12 - Embedded Adaptec Drivers

6Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable.

Seite 13 - Disclaimer

7Plug one end of the cable to the Wide SCSI connector on the Adaptec SCSI Card 29320. Plug the other end of the cable to a terminated Ultra/Fast Wide

Seite 14 - ■ EN55024 (1998) Immunity:

8Plug the other end of the cable to a terminated Ultra/Fast Narrow SCSI device.If you have other Ultra/Fast Narrow SCSI devices, attach them to the co

Kommentare zu diesen Handbüchern

Keine Kommentare