Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Bedienungsanleitung PDF herunterladen (Seite 183)

7-13

SCO UnixWare Installation

[xxxxx021] Target device protocol error

An unexpected event occurred during data transfer between the

adapter and target device. Normally, this indicates a faulty or non-

compliant target device.

[xxxxx022] Adapter or target device protocol error

The adapter or target device has broken the communication

protocol. A badly behaving device could be cause this message to

appear. Normally this is not a serious problem. If you get this

message frequently over a short period of time, it could indicate that

the device or system is malfunctioning. Unplug or power down

unused devices to see if the problem persists.

[xxxxx023] Target device parity error

The driver has detected a parity error by the target device. Try

decreasing the transfer rate or disable the Ultra SCSI speed in

SCSISelect. Also, make sure you are using good-quality SCSI cables.

[xxxxx024] Data overrun or underrun

The adapter was given more or less data than was expected.

[xxxxx030] Target Device busy

The target device reports a busy status. Another program might

already be using this device.

[xxxxx031] Target device queue full

The target device internal buffer is full.

[xxxxx032] Target device busy

The target device reports a busy status. Another program may

already be using this device.

[xxxxx041] Command aborted

[xxxxx042] Command aborted

[xxxxx043] Command aborted

[xxxxx044] Command aborted

[xxxxx045] Command aborted

An internal condition caused the driver to abort the command. In

most cases, the command is retried and is recovered, and normal

operation continues.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 189 190

Keine Kommentare

Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Bedienungsanleitung Seite 183