Adaptec Workstation x2100 Installationsanleitung PDF herunterladen (Seite 31)

Chapter 2 Hardware Installation and Removal 13

FIGURE 2-2 Installing the BBU

5. Place a spacer over each screw.

The BBU connector on the HBA is between the two screw holes closest to the

right edge of the HBA.

6. Line up the BBU connector on the BBU module with the connector on the HBA.

The screws you inserted will line up with matching holes in the BBU.

7. Gently press down on the right edge of the BBU module until the connectors

click into place.

Caution – DO NOT force the connection. If a gentle push does not mate the

connectors, realign the components and try again.

8. Obtain the three nuts from the BBU kit, and for each nut, do the following:

a. Place the nut onto the screw and hold the nut in place.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 133 134

Keine Kommentare

Adaptec Workstation x2100 Installationsanleitung Seite 31