Adaptec 4000SAS Betriebsanweisung PDF herunterladen (Seite 117)

Appendix E: Using the Adaptec Flash Utility ● 117

Creating the Firmware Floppy Disks

Note: You will need at least two bootable MS-DOS floppy disks to

complete this task.

You can’t create a bootable floppy disk using Windows 2000.

To create the firmware floppy disks:

Create a bootable MS–DOS floppy disk and copy these files to it:

● AFU

.exe

●

xxx

01.ufi

where xxxx is the model number of your controller.

2 Create additional bootable MS–DOS floppy disks and copy each

additional

xxx

0x.ufi

file to a separate floppy disk. (Some RAID

controllers have two UFI files; some have four. Each goes onto its

own floppy disk.)

3 To use a menu-based AFU, see below.

To run the AFU from the command line, see page 119.

Running the Menu-based AFU

Note: You can also run the AFU from the command line (see page 119).

To run the menu-based AFU:

1 Shut down your operating system and reboot to DOS from a

bootable MS-DOS floppy disk or from a DOS partition on a

bootable drive. (You can use a disk drive connected to the controller

you are updating.)

2 At the DOS command prompt, type AFU with no arguments.

The AFU’s main menu is displayed.

3 Select Select Controllers, then select the Adaptec RAID controller(s)

to be flashed.

To update multiple RAID controllers in the same system, update the

boot controller’s flash first, restart the computer, then update the

flash for the remaining controllers.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 133 134

Keine Kommentare

Adaptec 4000SAS Betriebsanweisung Seite 117