Adaptec 2920C - AHA Installationsanleitung PDF herunterladen (Seite 4)

Step 3: Insert the host adapter in the slot; press

down firmly so that the bus contacts are securely

seated in the slot. Secure it with the screw you

removed in Step 2.

Step 4: Prepare each internal SCSI device for

installation. If you are installing External SCSI

devices only, skip to Step 10.

■ Make sure all SCSI devices (internal and external) are

assigned a unique SCSI ID from 0 to 6. Refer to the

device’s documentation for instructions on setting

the SCSI ID.

If you plan to boot your computer from a SCSI hard

disk drive, assign SCSI ID 6 to this drive.

■ Install (or enable) terminators on the internal device

you are attaching to the end of the cable. Remove (or

disable) terminators on all devices that you are install-

ing between the end of the cable and host adapter.

On most internal SCSI devices the termination setting

is controlled by setting a jumper or a switch, or by

physically removing or installing a resistor module(s).

Refer to the device’s documentation to determine

how to enable or disable termination on your particu-

lar device.

Step 5: Install and mount each internal SCSI

device in an available drive bay inside your

computer. (Refer to your computer and device

documentation for instructions.)

PCI Expansion Slot

(typically white or ivory)

Host Adapter Bracket

Expansion Slot

Cover Screw

Bus Contacts

Termination

Disabled

Termination

Enabled

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Adaptec 2920C - AHA Installationsanleitung Seite 4