Adaptec GDT8546RZ - ICP Vortex RAID Controller Betriebsanweisung PDF herunterladen (Seite 7)

Hardware Installation and User Guide 7

Hardware Installation

Figure 3-1. ICP SATA/PATA Adapter Layout

3.1.2 Installation of the ICP SATA/PATA Adapter

1. Plug the SATA/PATA Adapter to the hard disk as shown in Figure 3-2.

Note:

The hard disk must be set as master (recommended) or to CSL (’Cable Select’). Usually

you will find the information about how to set the corresponding jumpers on a sticker on

the hard disk itself or within the hard disks manual.

Warning:

Please use the correction orientation while connecting the adapter. If the adapter is

connected the wrong way, this may cause serious damage to the adapter or the

hard disk drive!

2. Then, connect the SATA cable to the SATA connector of the ICP SATA/PATA Adapter.

3. At least, connect the power cable to the power connector of the ICP SATA/PATA

Adapter (small power connector) and to the PATA hard disk drives (large connector).

The Y-power cable then needs to be connected to a power cable from the power

supply.

Note:

The ATA hard disk, the SATA I/O cable and the power cord are coded, that means they

only fit in one way to the connector of the ICP SATA/PATA Adapter.

1 2 3 4 5 6 7 8

Keine Kommentare

Adaptec GDT8546RZ - ICP Vortex RAID Controller Betriebsanweisung Seite 7