Adaptec SANbloc S50 Installationsanleitung

SANbloc S50 JBOD Enclosure Quick Start GuideUsing the SANbloc S50 JBOD EnclosureQuick Install Guidewww.snapserver.com

SANbloc S50 SAS JBOD Quick Install Guide 8Connecting the EnclosureFollow the instructions appropriate for your configuration.Connecting to the Host Sy

9 SANbloc S50 SAS JBOD Quick Install Guide1 Use a 4x external SAS cable to connect the EXP port on the first enclosure to the HOST port on a second SA

SANbloc S50 SAS JBOD Quick Install GuidePowering On1 Using the included power cords, connect each Advanced Power and Cooling (APC) unit to an AC power

11 SANbloc S50 SAS JBOD Quick Install GuideRegistering Your SANbloc S50 EnclosureRegister your enclosure at http://register.adaptec.com.Getting HelpFo

SANbloc S50 SAS JBOD Quick Install GuideAdaptec, Inc. Worldwide Limited WarrantyThe Snap Server Storage Solution hardware carries a Limited Warranty f

13 SANbloc S50 SAS JBOD Quick Install GuidePURPOSE, OR NON-INFRINGEMENT, OR A WARRANTY THAT THE PRODUCT WILL OPERATE ERROR FREE.IN NO EVENT SHALL ADAP

SANbloc S50 SAS JBOD Quick Install GuideFCC NotificationAuthorized ServiceOnly an authorized service representative can service the Server. Failure to

15 SANbloc S50 SAS JBOD Quick Install GuideConnecting to the Main Power — Install the server near an easily accessible power source. Make sure the pow

SANbloc S50 SAS JBOD Quick Install Guide• Liquid has penetrated the server.• The server has been exposed to moisture.• The server continues to operate

COPYRIGHTCopyright © 2007, Adaptec, Inc. All rights reserved worldwide.Information in this document is subject to change without notice and does not r

691 Milpitas Blvd.Milpitas, CA 95035 USA408-957-2550www.snapserver.com©2007 Adaptec, Inc.All rights reserved. SnapServer, Adaptec and the SnapServer l

1 SANbloc S50 SAS JBOD Quick Install GuideSANbloc S50 SAS JBOD Quick Install GuideThis Quick Installation Guide describes how to install and connect t

SANbloc S50 SAS JBOD Quick Install Guide 2Preparing for Installation1 Carefully read Safety Notices on page 14.2 Remove all the components from the pa

3 SANbloc S50 SAS JBOD Quick Install Guide2 Secure the front rails to the front supports of the rack, using the screws or nuts included in the kit. (U

SANbloc S50 SAS JBOD Quick Install Guide 45 Slide the enclosure onto the rails, then push it all the way back until the rackmount ears are flush again

5 SANbloc S50 SAS JBOD Quick Install GuideInstalling the Disk DrivesCaution Acclimate new disk drives to room temperature before you install them.Bef

SANbloc S50 SAS JBOD Quick Install Guide 6Unsupported Disk Drive CombinationsInstalling the Disk DrivesNote Install the disk drives from left to righ

7 SANbloc S50 SAS JBOD Quick Install Guide4 Gently push the lever until it meets the latch on the left side of the drive slot and clicks into place.5