Adaptec APA-1460 Installationsanleitung PDF herunterladen (Seite 4)

Installing the

SlimSCSI Adapter

Follow these steps to physically install the SlimSCSI

adapter and connect your SCSI devices to it.

1 Connect the SlimSCSI connector to the SlimSCSI

adapter, as shown below:

Note: Your adapter cable may look different

from the one shown in the illustrations.

2 Insert the SlimSCSI adapter in a PCMCIA Type II,

PCMCIA Type III, or Toshiba Type IV slot on your

portable PC.

3 Plug the connector on the other end of the SlimSCSI

cable into a SCSI device, as shown below:

4 To connect other external SCSI devices, obtain addi-

tional external cables and daisy-chain each device to

the previous device, as shown below:

Daisy-chaining means that a cable runs from the

SlimSCSI adapter to a SCSI connector on the first

SCSI device; a second cable connects the first SCSI

device to the next SCSI device, and so on. You can

daisy-chain up to seven external SCSI devices.

5 Terminate the last (or only) SCSI device connected to

the SlimSCSI adapter.

Most SCSI devices are terminated with a jumper or

switch near the SCSI connector. On some SCSI

devices, you must physically remove or install termi-

nator resistor modules. See the device documentation

for more information.

Note: The SlimSCSI adapter is actively termi-

nated by default, and its termination cannot be

changed.

SlimSCSI Adapter

(male) Connector

Terminator

SCSIDevice

Terminator

SCSI Devices

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Adaptec APA-1460 Installationsanleitung Seite 4