Adaptec AFW-1430 Bedienungsanleitung PDF herunterladen (Seite 12)

APSoft

12 CardBus FireWire Enabler for DOS

Diagnostics and Fine-tuning

/F=filename

Specifies the initialization file pathname.

By default the initialization file has the same name as the Enabler, but with

extension .INI (i.e., FWENAB.INI). Enabler will be looking for the .INI file in

the same subdirectory where enabler itself is located.

Using /F parameter user may override path and name of the default

initialization file. (E.g., /F:E:\Settings\fwenab.ini)

/V[:<file>]

Verbose mode: Configuration steps will be outlined on console or to file (if

file pathname is specified).

/FL

Flush log file to disk immediately after each update (may be useful in case of

system hang).

/ID

Displays identified drive information.

/Ln:Letter

Specifies the drive letter assigned to partition 'n', where n could be in range of

0 to 9 (E.g. /L0:M /L1:K /L2:Z.)

Drive letters selected by the user can only be taken into account if the Enabler

is loaded in TSR mode (e.g., from AUTOEXEC.BAT or command line), and

will be ignored if the device driver is loaded from CONFIG.SYS.

User may assign more than 10 drive letters using the .INI file.

/DOSONLY

By default, Enabler assigns drive letters to all found drive partitions regardless

the file system. This mode allows e.g. reformat unrecognized file system to

one supported by DOS.

If /DOSONLY switch is added to the command line, the drive letters will be

assigned only to partitions with file system recognized by DOS (FAT12 &

FAT16 under DOS 6.x and FAT12, FAT16 & FAT32 under DOS.

Use this mode if you plan to install third-party file system driver for non-DOS

partitions. For example, Symantec Norton Ghost 8.x contains a built-in NTFS

driver allowing backup/restore operation to/from NTFS drive under DOS.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Adaptec AFW-1430 Bedienungsanleitung Seite 12