Adaptec APA-358 Bedienungsanleitung PDF herunterladen (Seite 54)

Eject Tape

This option configures SnapBack to eject the tape after a

successful backup. If you are planning to mount a volume

after a backup is completed, leave this setting turned off

(the default). This option should not be used on manual

eject tape drives.

Note > SnapBack will not eject the tape if the backup was aborted. For

administrators doing nightly backups, this is an indication that a backup

was successful without consulting the log file.

Invalidate Header

This will configure SnapBack to invalidate a backup tape

if a problem occurs during backup. This prevents any

misconception that a backup was good when it was not

completed successfully.

Win NTWin NT

Overwrite Last Backup

SnapBack will not overwrite the previous backup tape by

default. This option must be set if you are using a single

tape to perform daily backups.

Note > Sound backup strategy requires that tapes be rotated. An absolute

minimum is three tapes rotated daily.

Backup Partitions Only

Enabling this option configures SnapBack to backup only

the partitioned area of the hard drive (as defined in the

master boot record). For example, if you have a 40MB DOS

partition and a 1023MB NetWare partition on a 2GB hard

drive, SnapBack would back up only 1063MB, as opposed

SnapBack Live! 54

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 150 151

Keine Kommentare

Adaptec APA-358 Bedienungsanleitung Seite 54