Adaptec 19160 - SCSI Card Storage Controller U160 160 MBps Installationsanleitung PDF herunterladen (Seite 26)

Adaptec SCSI Card 19160 User’s Reference

SCSI Bus Interface Definitions

■

SCSI card SCSI ID—(Default: 7) Sets the SCSI ID for the SCSI

card. The Adaptec SCSI Card 19160 is set at 7, which gives it

the highest priority on the SCSI bus. We recommend that you

do not change this setting.

Note:

Some operating systems will not work if the

SCSI card has an ID other than 7.

■

SCSI Parity Checking—(Default: Enabled) When set to

Enabled, verifies the accuracy of data transfer on the SCSI bus.

Leave this setting enabled unless any SCSI device connected to

the Adaptec SCSI Card 19160 does not support SCSI parity.

■

SCSI card SCSI Termination—(Default: Automatic) Deter-

mines the termination setting for the SCSI card. The default

setting for both the LVD/SE and SE connectors is Automatic,

which allows the SCSI card to adjust the termination as needed

depending on the configuration of the connected SCSI devices.

We recommend that you do not change this setting.

Boot Device Options

■

Boot SCSI ID—(Default: 0) Specifies the SCSI ID of your boot

device. We recommend that you do not change the default

setting.

■

Boot LUN Number—(Default: 0) Specifies which LUN (Logi-

cal Unit Number) to boot from on your boot device. This set-

ting is not valid unless Multiple LUN Support is Enabled (see

Advanced Configuration Options on page 22).

SCSI Device Configuration

SCSI Device Configuration options can be set individually for each

connected SCSI device.

Note:

To configure settings for a SCSI device, you must

know its SCSI ID (see Using SCSI Disk Utilities on page 24).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Keine Kommentare

Adaptec 19160 - SCSI Card Storage Controller U160 160 MBps Installationsanleitung Seite 26