Adaptec 19160 - SCSI Card Storage Controller U160 160 MBps Installationsanleitung PDF herunterladen (Seite 28)

Adaptec SCSI Card 19160 User’s Reference

Advanced Configuration Options

Note:

Do not change the Advanced Configuration Options

unless absolutely necessary.

■

Reset SCSI Bus at IC Initialization—(Default: Enabled) When

set to Enabled, the SCSI card generates a SCSI bus reset during

its power-on initialization and after a hard reset.

■

Display <Ctrl> <A> Messages during BIOS Initialization—

(Default: Enabled) When set to Enabled, the SCSI card BIOS

displays the

Press <Ctrl> <A> for SCSISelect (TM) Utility!

message on

your screen during system bootup. If this setting is disabled,

you can still invoke the SCSISelect Utility by pressing <Ctrl>

<A> after the SCSI card BIOS banner appears.

■

Extended BIOS Translation for DOS Drives > 1 GByte—

(Default: Enabled) When set to Enabled, provides an extended

translation scheme for SCSI hard disks with capacities greater

than 1 GByte. This setting is required only for MS-DOS 5.0 or

above; it may be required for other operating systems.

Caution:

Changing the translation scheme may

destroy all data on the drive. Be sure to back up the

data before changing the translation scheme. If this

setting is changed we recommend that you low level

formatted the drive after changing the setting.

Use the MS-DOS

Fdisk

command to partition a disk larger

than 1 GByte controlled by the SCSI card BIOS, when using

DOS, Windows 95/98 or Windows NT

. Check the operating

system documentation for information on any partition size

limitations.

■

Verbose/Silent Mode—(Default: Verbose) When set Ve r b o s e ,

the SCSI card BIOS displays the host adapter model on the

screen during system bootup. When set to Silent, the message

will not be displayed during bootup.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Keine Kommentare

Adaptec 19160 - SCSI Card Storage Controller U160 160 MBps Installationsanleitung Seite 28