Adaptec RAID 2810SA Betriebsanweisung PDF herunterladen (Seite 20)

1-8

Introduction

The Adaptec 2810SA controller supports two types of hot spares:

■ Global—Protects every array that the drive has enough

available capacity to protect.

■ Dedicated—Protects only the array that it has been assigned to

protect.

Automatic Failover

This feature allows the controller to automatically rebuild an array

when a failed drive is replaced with a new drive. This feature

applies only to redundant arrays in SES- or SAF-TE-enabled drive

enclosures. See page A-10 for details.

Overview of the Installation Process

The following steps provide an overview of the process of

installing, setting-up, and configuring the controller:

1 Read and understand this entire chapter.

2 Install and configure the controller and hard drives according to

the instructions in Chapter 2, Installing the Controller.

3 In Chapter 3, Installing the Driver, the procedure depends on

your system:

In a new system:

a Build the array.

b Install the controller driver at the beginning of the operating

system installation.

In an existing system:

a Install the controller driver.

b Build the array.

4 Install Adaptec Storage Manager – Browser Edition as

described in Chapter 4, Installing Adaptec Storage Manager –

Browser Edition.

5 Register online to receive important information about your

controller at

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 152 153

Keine Kommentare

Adaptec RAID 2810SA Betriebsanweisung Seite 20