Adaptec 9210LP Installationsanleitung PDF herunterladen (Seite 10)

Adaptec Fibre Card 9210LP

Installing the Driver When Installing Windows NT 4.0

The Adaptec Fibre Card 9210LP driver is not embedded on the

Windows NT 4.0 installation disks (or CD-ROM) and must be

added during Windows NT installation. See your operating

system documentation for instructions.

Completing a Fresh Windows NT 4.0 Installation

From Floppy Disk

Start your system with the Windows NT 4.0 Boot Disk in the

floppy disk drive.

When prompted, insert disk #2 into your floppy disk drive. After

a few moments you will see a blue screen. To set up Windows NT

now, press Enter.

Press S to skip auto-detection of devices in your system.

Press S again to specify an additional device.

Press Enter to select Others; insert the Adaptec Fibre Channel

Drivers disk in your floppy disk drive.

Using the arrow keys, select the following driver and press Enter:

Adaptec 1Gb/2Gb Family PCI Fibre Channel Controller

(NT 4.0)

INSTALLING THE ADAPTEC FIBRE CARD 9210LP

EVICE DRIVER FOR WINDOWS NT 4.0

In order to boot the operating system from a drive

attached to the Adaptec Fibre Card 9210LP, the Adaptec Fibre

Card 9210LP must be connected to a drive without a Fibre

Channel switch attached.

NOTE

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

STEP 6

9210IG.book Page 9 Monday, April 2, 2001 11:13 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Keine Kommentare

Adaptec 9210LP Installationsanleitung Seite 10