Adaptec APA-460 Installationsanleitung PDF herunterladen (Seite 41)

A-9

Card and Socket Services Installation

APA-460 Installation Guide

Stock Number: TR510070-00, Rev. B Page: A-9

Print Spec Number: TR490120-00

Current Date: 3/25/94 ECN Date: 4/5/94

IDE/ATA Support (atadrv.exe and atainit.exe)*

atadrv.exe

is a block device driver that supports ATA/Type 3 hard

drive PCMCIA cards. The

atainit.exe

utility places a hard disk parti-

tion table onto a blank ATA drive. This utility initializes the ATA

drive in the same manner as

fdisk

does with a standard hard drive.

Windows Enhanced Mode PCMCIA Support (ssvcd.386)*

This Virtual Communications driver permits hot insertion/removal

of communications I/O and memory cards within Windows.

Card Boot*

The Card Boot (

int13.rom, endbootb.com, endbootr.com,

flashfmt.exe

) product consists of a suite of components that provide

boot capabilities to SRAM or Intel Series II cards.

int13.rom

, the boot extension ROM, redirects reads of drive

to the

PCMCIA card.

int13.rom

is a binary image of a ROM file that should

be put into the system ROM and will be found during the standard

BIOS extension ROM scan.

endbootb.com

and

endbootr.com

turn off the drive

redirection,

making floppy drive

accessible after the boot from the PCMCIA

card is complete.

endbootb.com

is used if the boot code is included

in the Int13 handler of a SystemSoft BIOS.

endbootr.com

is used if

the boot code is included in extension ROM.

The

flashfmt.exe

utility creates a bootable partition on a Series 2

Flash card.

Resource Allocation Utility (csalloc.exe)

csalloc

is a DOS utility that scans the system for available memory,

I/O Port, and IRQ resources. It then writes this information to the

file

csalloc.ini

, which is used by Card Services to determine what

system resources are available for PC Card configuration.

csalloc

can be run in two modes, both of which must be run from the

DOS command line (they cannot be run from within a Microsoft

Windows MS-DOS

Prompt window).

csalloc /g

Runs

csalloc

in nondisplay mode. When you enter this command at

the DOS prompt, you are prompted to remove PC Cards that are

present in the system. Remove any inserted PC Cards, then press

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

Adaptec APA-460 Installationsanleitung Seite 41

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Adaptec APA-460