Adaptec 6405 Betriebsanweisung PDF herunterladen (Seite 40)

7. Install the mounting plate in the empty slot next to the controller, as shown in the next gure. After

securing the mounting plate to the card cage, verify that the supercapacitor module and mounting

plate sit above (and do not touch) the PCIe slot.

Gap

8. (Adaptec Series 6 controllers only) Connect your computer's disk activity LED cable to the LED

connector on the controller (marked on the gures in About Your RAID Controller on page 17).

Ensure that the positive lead of the LED cable (usually a red wire or a wire marked with a red stripe)

is attached to pin 1.

9. (Adaptec Series 6 controllers only) Optionally, connect your RAID controller's I2C connector (not

available on all models) to an I2C connector on an internal backplane or enclosure, using an I2C

cable. For more connection details, see About Your RAID Controller on page 17.

10. Prepare and install your internal disk drives, following the instructions in Connecting Disk Drives to

Your Controllers on page 41.

If you are not installing internal disk drives, close your computer cabinet, reattach the power cord,

then continue with Connecting External Devices on page 42.

11. Restart your computer.

The supercapacitor starts charging automatically. It should reach full charge in 3-4 minutes.

40Proprietary and Condential to PMC-Sierra, Inc.

Document No.: CDP-00277-02-A Rev. A, Issue:

Serial Attached SCSI RAID Controllers Installation and User's Guide

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 109 110

Keine Kommentare

Adaptec 6405 Betriebsanweisung Seite 40