Adaptec 6405 Betriebsanweisung PDF herunterladen (Seite 50)

Installing with Windows

Note: The following instructions apply to all supported Windows operating systems.

You will need your Windows Installation CD to complete this task.

To install the Adaptec RAID controller driver while installing Windows:

1. Insert your Windows CD, then restart the computer.

2. Follow the on-screen instructions to begin the Windows installation.

3. When prompted to specify a location for Windows, select Load Driver.

4. Insert the Adaptec Installation DVD, browse to the driver location, then click OK.

The 64-Bit driver is located within the AMD64 folder.

5. When the Adaptec driver is found, press Next.

You may see the message ‘No drives were found’. Repeat Step 3, Step 4 (browse to driver location),

and Step 5. On the second attempt, the driver will load successfully.

6. Click Next again to accept the default partition conguration, or refer to your Windows documentation

to congure partitions manually.

7. Follow the on-screen instructions to complete the installation.

8. Continue with Managing Your Storage Space on page 64.

Installing with Red Hat Linux 5 or Cent OS 5

Note: You will need the installation CD for your operating system to complete this

task.

To install the Adaptec RAID controller driver while installing Red Hat Linux 5 or Cent OS 5:

1. Insert your installation CD.

2. Restart your computer.

3. When the rst installation screen appears, insert the USB driver disk.

4. Type this command at the Boot: prompt and press Enter:

linux dd

5. Select Yes to indicate that you have a driver disk, then select the driver image from the USB drive

(typically, /dev/sda1).

6. Complete the Linux installation, following the on-screen instructions.

7. Continue with Managing Your Storage Space on page 64.

Installing with Red Hat Linux 6, Cent OS 6, or Fedora Linux

Follow the instructions in this section to install the controller driver with Red Hat Linux 6, Cent OS 6, or

Fedora Linux. We recommend that you install the driver with Dynamic Kernel Module Support, or DKMS.

DKMS ensures that the driver remains installed across OS or online updates. The DKMS instructions are

valid for Red Hat 6 and Cent OS 6 only.

Red Hat Linux 6, Cent OS 6 with Dynamic Kernel Module Support

Note: You will need your OS installation CD and a USB ash drive to complete this

task. You must have root privileges to install the driver image.

To install the Adaptec RAID controller driver while installing Red Hat 6 or Cent OS 6:

1. Copy aacraid-1.2.1.29900-dd.img and aacraid.conf from the Linux driver directory on the

Adaptec Installation DVD to a USB ash drive. Remove the USB drive when you are nished.

2. Insert the OS installation CD, then restart your computer.

3. When the graphical Welcome screen appears, press Tab, then insert the USB driver disk.

50Proprietary and Condential to PMC-Sierra, Inc.

Document No.: CDP-00277-02-A Rev. A, Issue:

Serial Attached SCSI RAID Controllers Installation and User's Guide

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 109 110

Kommentare zu diesen Handbüchern

Keine Kommentare

Adaptec 6405 Betriebsanweisung Seite 50

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für RAID-Kontroller Adaptec 6405