Adaptec AFW-1430 Bedienungsanleitung PDF herunterladen (Seite 7)

CardBus FireWire Enabler for DOS 7

C H A P T E R

Installation

The Enabler may be installed either in CONFIG.SYS, AUTOEXEC.BAT or

started from DOS command line. It’s possible to relocate enabler into upper

memory using DEVICEHIGH or INSTALLHIGH statements in CONFIG.SYS.

The Enabler provides several command line switches allowing fine-tuning of the

driver. In more complicate cases you may create an initialization file with very

detailed configuration instructions.

It is recommended that you fine-tune CardBus Enabler switches starting

CardBus Enabler from the command line. After switches are set, you can place

call of CardBus Enabler either to CONFIG.SYS or to AUTOEXEC.BAT.

Deployment

CardBus FireWire Enabler is able provide support of FireWire cards and

devices without loading any additional drivers.

For use CD-ROM you will also need to load MSCDEX.EXE in your

AUTOEXEC.BAT.

CardBus FireWire Enabler may allocate the required memory automatically (see

“Resource Management” chapter for details).

To be available inside of 1

MB (required if SBP2ASPI driver is used) memory

should not be shadowed by BIOS and should be excluded from memory

management by EMM386.EXE.

If CardBus FireWire Enabler provides support of FireWire cards without

SBP2ASPI driver then there is no need to allocate memory below the 1st MB

(memory anywhere in 4GB address space may be used).

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Adaptec AFW-1430 Bedienungsanleitung Seite 7