Adaptec SCSI RAID 2120S Installationsanleitung PDF herunterladen (Seite 52)

3-21

container Commands

container create raid5

To create a RAID 5 array, use the container create raid5

command. The RAID 5 array must have a minimum of three disks.

When creating the RAID 5 array, you must initialize the array

parity by using the scrub method (the /scrub

switch).

Notes

If you created a RAID 5 array you can run the list devices

command on the NetWare console to verify its creation and then

create the necessary NetWare disk partitions and volumes.

For information on how to create partitions and volumes, see the

appropriate NetWare documentation.

Syntax

container create raid5 [/cache{=boolean}]

[/clear{=boolean}] [/stripe_size{=integer}]

[/label{=string}] [/scrub{=boolean}]

[/wait{=boolean}] {free_space} [{scsi_device}...]

Parameters

{free_space}

Specifies the SCSI device and its associated freespace used to

create the RAID 5 array.

For further details, see free_space on page 1-11.

{scsi_device}...

Specifies one or more SCSI devices. A SCSI ID consists of a

SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through

15 inclusive), and SCSI device logical unit number (0 through 7

inclusive). See the installation guide for your controller to

determine the number of buses it actually supports.

For further details, see scsi_device on page 1-10.

The command uses the freespace(s) from the SCSI device(s)

you specify to create the RAID 5 array. The size that the

command uses from these device(s) is identical to the one you

specify in the

free_space

parameter. The minimum number

of partitions in a RAID 5 array is 3, and the maximum number

of partitions is 16.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 277 278

Keine Kommentare

Adaptec SCSI RAID 2120S Installationsanleitung Seite 52