Adaptec AAA-UDMA Installationsanleitung PDF herunterladen (Seite 21)

2-7

Installing the Hardware

Mounting UDMA Drives and Connecting Power Cables

Each UDMA drive must be mounted in an available drive bay inside

your computer (as shown in Figure 2-5) and connected to a power

cable from your computer’s power supply. Refer to your computer

and device documentation for instructions on installing devices

inside your computer.

Figure 2-5. UDMA Drive Mounted in Drive Bay

Additional Hints for UDMA Drives

All UDMA Drives

■

If you are booting your system from a single UDMA drive or

bootable array, the boot order (or

virtual device order

) of the

drive or array must be set to 0. (See

Making the Array Bootable

on page 3-8.)

Cable Lengths

■

To connect a UDMA drive to the AAA-UDMA, a UDMA/66

cable is required. Each UDMA/66 cable should not exceed

18-inches in length. Adaptec strongly recommends that you

use only the two-connector UDMA/66 cables provided by

Adaptec.

UDMA Drive

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Keine Kommentare

Adaptec AAA-UDMA Installationsanleitung Seite 21