Adaptec 2120S - SCSI RAID Controller Betriebsanweisung PDF herunterladen (Seite 152)

5-104

Adaptec SCSI RAID Software Reference Guide

The following example assigns two SCSI failover disks to all arrays.

If you assign only one SCSI disk as a failover device, ensure that

there is sufficient freespace. If you assign more than one SCSI disk as

failover devices, you need ensure that only one of these disks has

sufficient space. The reason for this is that the failover operation will

look for the disk that has enough space.

AAC0>container set global_failover (1,2,0) (1,3,0)

Executing: container set global_failover (CHANNEL=1,ID=2,LUN=0)

(CHANNEL=1,ID=3,LUN=0)

Use the container show failover command (with or without the

/global

switch) after using the container set failover

command to display information about the array(s) just assigned

failover disk(s), as in the following example:

AAC0>container show failover /global

Executing: container show failover /global=TRUE

container Scsi C:ID:L

--------- ----------------------------------

GLOBAL 1:02:0 1:03:0

As the example shows, the display indicates that SCSI devices (1,2,0)

and (1,3,0) are assigned as failover devices for all arrays (the word

GLOBAL appears in the array column).

Related Information

container commands:

■ container list (page 5-54)

■ container remove failover (page 5-86)

■ container remove global_failover (page 5-90)

■ container set failover (page 5-101)

■ container show failover (page 5-116)

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 353 354

Keine Kommentare

Adaptec 2120S - SCSI RAID Controller Betriebsanweisung Seite 152