Adaptec 2120S - SCSI RAID Controller Betriebsanweisung PDF herunterladen (Seite 60)

5-12

Adaptec SCSI RAID Software Reference Guide

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

F: 0 Volume 30M NTFS

63 Mirror 15MB 0:02:0 64.0KB: 15.0MB

0:04:0 64.0KB: 15.0MB

62 Mirror 15MB 0:03:0 64.0KB: 15.0MB

0:05:0 64.0KB: 15.0MB

The following list describes the change to the display as the result of

creating a multilevel array of mirror sets with the container

create mmirror command:

■ The Dr column is blank to indicate that the newly created

mirror sets (63 and 62) do not have a drive letter assigned to

them.

■ The Type column displays Mirror for arrays 63 and 62 to

indicate that the underlying arrays are mirror sets.

■ The State column displays the state of the arrays, which in this

example are all in the Normal state.

Note that this column appears only if you specify the /full

switch with the container list command.

■ The Scsi C:ID:L column displays the SCSI device ID for the

disk(s) on which the underlying mirror set(s) reside. In the

example, mirror set 63 resides on disk 0:02:0 and 0:04:0. Mirror

set 62 resides on disk 0:03:0 and 0:05:0.

■ The Partition Offset:Size column displays the partition

offset(s) and size(s) for the underlying mirror set(s). In the

example mirror set 63 and 62 have partition offsets of 64.0 KB

and sizes of 15.0 MB.

If a partition is dead, the “:” (colon) in the Partition Offset:Size

column changes to a “!” (exclamation point). See the disk

remove dead_partitions

(page 7-9) command for

more information on dead partitions.

Related Information

container commands:

■ container create mirror (page 5-5)

■ container list (page 5-54)

■ container promote (page 5-69)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 353 354

Keine Kommentare

Adaptec 2120S - SCSI RAID Controller Betriebsanweisung Seite 60