Adaptec 2120S - SCSI RAID Controller Betriebsanweisung PDF herunterladen (Seite 86)

5-38

Adaptec SCSI RAID Software Reference Guide

Use the container list command after executing the

container create volume

command to display information

about the volume set, as in the following example:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB

The following list describes the columns that contain information as

the result of creating a volume set with the container create

volume

command:

■ The Num Label column displays the ID number of the newly

created volume set, which in the example is 0.

If you specify a label when creating the volume set, it appears

in this column. Because no label was specified when the

volume set was created, no label appears in the column.

On UNIX systems, the root special file associated with the

array also appears in this column.

■ The Type column displays Volume to indicate that the newly

created array is a volume set.

■ The Total Size column displays the value(s) specified in the

free_space parameter(s), which in the example is 15.0 MB.

■ The Usage column displays None to indicate that the newly

created volume set does not have a file system on it. To create

an NTFS or FAT file system on an array, use the

container

format

command.

■ The Scsi C:ID:L column displays the SCSI device ID for the

disk on which you created the volume set, which in the

example is 0:02:0.

■ The Partition Offset: Size column displays the partition offset

and the size of the newly created volume set’s partition, which

in the example are 64.0 KB and 15.0 MB. The size is the size

you specified in the

free_space parameter(s).

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 353 354

Keine Kommentare

Adaptec 2120S - SCSI RAID Controller Betriebsanweisung Seite 86