Adaptec GDTSETUP Bedienungsanleitung PDF herunterladen (Seite 132)

132

(E)

Now use the MS-DOS program FORMAT to transfer MS-DOS to the primary partition

you have just created.

To do so, enter

A:\> FORMAT C: /S <ENTER>

(F)

To complete the installation of MS-DOS, use the MS-DOS commands COPY or XCOPY

to transfer the desired MS-DOS files.

A different and maybe even more elegant method of installing MS-DOS is to use the SETUP

program of MS-DOS versions 5 and 6. In this case, you only have to create and activate a

partition with GDTSETUP or FDISK. Then boot the system from the first floppy disk deliv-

ered with MS-DOS. MS-DOS SETUP will take care of all the rest.

'&21),*6<6DQGWKH'ULYHU*'7;(;(

GDTX000.EXE is the high performance MS-DOS driver for all ICP Controllers. In order to

obtain the best performance of the ICP Controller under MS-DOS, this driver should be

listed in the first line following the HIMEM.SYS device command in the CONFIG.SYS file.

When loaded, GDTX000.EXE replaces the BIOS EPROM (the so-called INT13H interface) of

the ICP Controller, and also offers a VDS (Virtual DMA Services) interface. This is of particu-

lar importance for Windows 3.x. When using GDTX000.EXE please observe the following:

 GDTX000.EXE must be loaded from the first line following the HIMEM.SYS device

command in the CONFIG.SYS file. If HIMEM.SYS is not loaded, it must be loaded from

the very first line of the CONFIG.SYS file.

 GDTX000.EXE can be loaded in the UMA.

 GDTX000.EXE is needed for an optimal use of Windows 3.x.

 The ICP Controller unfolds its full capacity under MS-DOS or Windows 3.x only when

GDTX000.EXE is installed.

 In order to load GDTSETUP under MS-DOS from disk, you need GDTX000.EXE.

 In the CONFIG.SYS file, GDTX000.EXE must be loaded before GDTASPI.EXE.

Below is an example of a CONFIG.SYS file which is essential for the MS-DOS configuration

device=c:\windows\himem.sys

device=gdtx000.exe

files=30

buffers=30

stacks=9,256

dos=high,umb

install=\dos\keyb.com GR,,\dos\keyboard.sys

shell=\COMMAND.COM /E:512 /P

device=gdtx000.exe

device=mouse.sys

device=\dos\setver.exe

device=\gdt\gdtaspi.exe

device=\aspi\aswcdnec.sys /D:CD-ROM

lastdrive=h

In this example, besides the GDTX000 driver, the GDTXDOS.EXE driver, the GDT ASPI Man-

ager and an ASPI Module for an NEC CD-ROM drive are loaded.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 217 218

Kommentare zu diesen Handbüchern

Keine Kommentare

Adaptec GDTSETUP Bedienungsanleitung Seite 132

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Adaptec GDTSETUP