Adaptec 2110S - SCSI RAID Controller Installationsanleitung PDF herunterladen (Seite 59)

3-24

Adaptec RAID Installation Guide

Installing the Driver in an Existing NetWare 4.2 Server

In this scenario, you are integrating an Adaptec RAID controller into

an existing Novell NetWare 4.2 server as a secondary controller. To

install the driver

1 Upgrade your NetWare server to the minimum patch level

specified by Novell.

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive and a

blank floppy disk in the floppy disk drive.

b Copy all the files in \packages\netware\4.11\driver to the

floppy disk.

c Remove the Adaptec RAID Installation CD and the driver

floppy disk.

3 Shutdown the server.

4 Install and configure the Adaptec RAID controller as a

secondary controller according to the instructions in Chapter 2.

Note the slot occupied by the controller; you will need this

information later in the install process.

5 Start up the server. During startup, press Ctrl+A to start

SMOR. Use SMOR to create the RAID. For details, refer to

Using SMOR on page 2-11.

6 Start NetWare.

7 When the console prompt appears, type load install and

press Enter.

8 Select Install a Product and press Enter.

9 Select Install a Product Not Listed and press Enter.

10 Insert the disk you created in Step 2 and install I

O and block

storage support only.

11 Accept the defaults for the remaining options.

12 Return to the main install screen and select NCF Options.

COMBINED RAID IG.BOOK Page 24 Tuesday, September 25, 2001 5:46 PM

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 105 106

Keine Kommentare

Adaptec 2110S - SCSI RAID Controller Installationsanleitung Seite 59