Adaptec 2110S - SCSI RAID Controller Installationsanleitung PDF herunterladen (Seite 66)

3-31

Installing the Driver

Linux

The Adaptec RAID controller supports Red Hat 7.0 and 7.1 and SuSE 7.0

and 7.1 with kernel versions 2.2.14-5.0, 2.2.16-22, 2.2.14, and 2.2.16.

Note: For the most up-to-date information on Adaptec’s

support of Linux, or to download driver sources, visit

http://linux.adaptec.com.

Caution: When adding a Zero Channel RAID (ZCR)

controller to an existing system, backup all data from

system drives prior to the installation. If the boot device is

connected to one of the onboard SCSI channels, the

operating system will need to be reinstalled after installing

the ZCR controller.

Installing the Driver in a New Linux System

In this scenario, you are installing the controller in a new Red Hat

Linux system.

Note: This installation procedure applies to Red Hat

Linux only.

To install the driver

1 Create the driver disk using the Adaptec RAID Installation CD.

a Insert the Adaptec RAID Installation CD.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of the CD functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

COMBINED RAID IG.BOOK Page 31 Tuesday, September 25, 2001 5:46 PM

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 105 106

Keine Kommentare

Adaptec 2110S - SCSI RAID Controller Installationsanleitung Seite 66