Adaptec 2200S - SCSI RAID Controller Installationsanleitung PDF herunterladen (Seite 42)

3-11

Installing the Driver

Red Hat Linux

Note:

A SCSI CD-ROM drive attached to the controller cannot

be used in any installation of an Adaptec SCSI RAID 2120S/

2200S to a system that will be running Linux. This restriction

isn’t just for the installation of the driver or the operating

system, but generally. The Adaptec SCSI RAID 2120S/2200S

Linux driver will not operate with anything but hard disk

drives.

Installing the Driver in a New Red Hat 7.2 Linux System

In this scenario, you are installing the controller in a new Red Hat

Linux system.

Note:

To install Red Hat to drives using an Adaptec SCSI

RAID 2120S/2200S, you need to download the updates disk

for the Anaconda Installer from www.redhat.com. A bug in

the Red Hat installer for 7.2 makes this necessary. This

updates disk will be used in the following installation steps.

To install the driver:

Install and configure your Adaptec SCSI RAID controller and

hard disk drives according to the instructions in Chapter 2.

Start the server. During startup, press Ctrl+A to start ARC. Use

ARC to create the RAID. For details, refer to Using the Adaptec

RAID Configuration (ARC) Utility on page 2-9.

Insert the Red Hat CD Disk 1 in the CD-ROM drive.

Start the system.

When the Red Hat welcome screen appears, type the following

at the boot prompt:

linux dd noprobe updates

When prompted, insert the driver disk you created at the

beginning of this chapter and select OK.

Insert the updates disk when prompted.

Follow the prompts to set up your preferred environment.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 66 67

Keine Kommentare

Adaptec 2200S - SCSI RAID Controller Installationsanleitung Seite 42