Adaptec ULTRA160 Betriebsanweisung PDF herunterladen (Seite 67)

5-9

UnixWare Installation

Troubleshooting

Problems and Solutions

My computer crashes or displays panic messages during the bootup procedure!

You may have to boot from the backup kernel created earlier, and

then perform the driver update procedure again.

To boot from the old kernel, follow these steps:

Reboot the computer.

At the Booting UNIX System… prompt or loading UnixWare

graphics, press the Spacebar.

For UnixWare 2.1x: From the [boot]# prompt, first type

KERNEL=old kernel (e.g., KERNEL=unix.work) and press

Enter. Then, type go and press Enter. Your computer should

now boot from the backup kernel created earlier in Installing

the Driver When UnixWare is Already Installed on page 5-3.

For UnixWare 7.01/7.1: From the [boot]# prompt, first type

BOOTPROG=old kernel (e.g., BOOTPROG=unix.work) and

press Enter. Then, type go and press Enter. Your computer

should now boot from the backup kernel created earlier in

Installing the Driver When UnixWare is Already Installed on

page 5-3.

To repeat the driver update procedure, follow these steps:

Follow the instructions in Removing the Driver on page 5-8 to

delete the driver from your computer.

Perform the driver update procedure again. See Installing the

Driver When UnixWare is Already Installed on page 5-3.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 77 78

Keine Kommentare

Adaptec ULTRA160 Betriebsanweisung Seite 67