Adaptec SAS RAID Controllers Installationsanleitung PDF herunterladen (Seite 103)

Appendix E Best Practices 89

Replacing an HBA On a SPARC System

Upon replacing an existing HBA card with a new card on a SPARC system, the new

card automatically detects the existing configuration upon installation and no further

action is required. However, if the new HBA is not seeing one or more volumes in the

existing configuration, rescan those volumes to enable their detection.

Replacing an HBA On an x64 System

Upon replacing an existing HBA card with a new card on an x64 system, the BIOS

RAID Configuration utility sends a warning message alerting you to a configuration

change during the initialization process of the new card. The existing drives and

volumes in the configuration will not be activated on the new card until you accept

the configuration change indicated in the warning message.

To activate the existing drives and volumes on the new card, do one of the following:

■ Upon receiving the configuration change warning message, press Enter to accept

the configuration change.

■ View the configuration change through the BIOS Configuration utility (press

Ctrl+A when prompted during POST), and accept the change from the utility.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 147 148

Keine Kommentare

Adaptec SAS RAID Controllers Installationsanleitung Seite 103