Adaptec AHA-1532P Betriebsanweisung PDF herunterladen (Seite 114)

Appendix C: Troubleshooting106

After the diskette is formatted and the operating system files are transferred, you will be

able to boot the computer from the diskette. If you restart your computer with the diskette

in the diskette drive, your computer boots using a minimal amount of conventional

memory. After you boot from the diskette, you can run Drive Image from either the

diskette or your hard drive.

If you want to create and restore images across a network, you will need to create a

network boot diskette.

Creating a CONFIG.SYS File on the Boot Diskette

If making an ordinary boot diskette doesn't free enough conventional memory, you can

create a customized boot diskette that will free even more conventional memory. (With the

customized diskette, you will free more conventional memory by loading some of the

DOS operating system into high memory.) To customize the diskette, you must create a

CONFIG.SYS file in the root directory (A:\). To create a CONFIG.SYS in the root

directory, perform the following:

At the DOS prompt, type drive: (where

drive

is the drive letter of the diskette

drive), then press <Enter>.

Verify that you have changed to the diskette drive (you see the drive:\> prompt).

Type EDIT CONFIG.SYS and press <Enter>.

This starts the DOS editor. (You will see a blank screen if no CONFIG.SYS currently

exists.)

In the editor, type the following:

DEVICE=C:\DOS\HIMEM.SYS

DEVICE=EMM386.EXE

DOS=HIGH,UMB

IMPORTANT!

All lines must be entered in the order shown. Windows users:

substitute DEVICE=C:\WINDOWS\HIMEM.SYS.

Click File

➤

Save to save the file.

Click File

➤

Exit to exit the editor.

You can now reboot your computer from the customized boot diskette. When DOS loads,

much of it is loaded into high memory, saving a maximum amount of conventional

memory.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 127 128

Keine Kommentare

Adaptec AHA-1532P Betriebsanweisung Seite 114