Adaptec AHA-1540CP Betriebsanweisung PDF herunterladen (Seite 102)

7-2

Adaptec 7800 Family Manager

Installing the Driver When Installing

SCO UnixWare

To install the

adsl20

adsl

adsb20

adsb

drivers at the same time you

install SCO UnixWare, follow the instructions below. The procedures are

the same for SCO UnixWare 2.0x and 2.1.

Insert the Install diskette of the SCO UnixWare package into the

floppy boot drive. Reboot your computer.

Wait for the first SCO UnixWare installation screen and prompt to

appear, then follow the onscreen instructions.

When prompted to either Install Host Bus Adapter Drivers or

Continue Installation, first remove the Install diskette, then select

Install Host Bus Adapter Driver and press Enter.

Insert the 7800 Family Manager Set diskette for UnixWare 2.x into

the primary floppy drive and press Enter (you cannot load drivers

from a secondary floppy drive).

As the driver loads, a message identifying the installed host adapter

briefly appears on screen. The installation process determines which

device drivers on the diskettes are needed.

If you have additional HBA diskettes, insert the next HBA diskette,

select Install Another HBA Diskette, and press Enter.

If all of your HBA diskettes have been installed, remove the last HBA

diskette, select Continue Installation, and press Enter.

If necessary, enter the DCU (Device Configuration Utility) to

view/change the SCO UnixWare device driver configuration data.

Follow the onscreen instructions to continue with installation. Refer

to the SCO UnixWare documentation and onscreen help files for help

in choosing options.

Note:

If your installation fails, do not attempt to use the update

installation pkgadd procedure to fix the installation. Follow the

instructions in the SCO UnixWare documentation and in this

document to retry the installation.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 119 120

Keine Kommentare

Adaptec AHA-1540CP Betriebsanweisung Seite 102