Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung PDF herunterladen (Seite 30)

Table-top stand for the SIERRA™ plus film digitizer 28

VIDAR Film Digitizer Installation Guide

6. Install the exit tray.

a. Position the exit tray below the digitizer, outside the mounting

bracket. Rest the bottom end of the exit tray on the outside of the “U”

tube. Secure the exit tray using the two captive thumbscrews (one on

each side).

Rest bottom of exit tray on "U"

tube as shown in this side view

Secure exit tray

with two captive

thumbscrews

(one on each side)

b. Snap the bottom of the exit tray over the “U” tube, so it rests on the

bar extending across the “U” tube.

Snap exit tray

behind "U" tube

Note:

Tighten by hand only.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 85 86

Keine Kommentare

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung Seite 30