Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung PDF herunterladen (Seite 65)

Operating the SIERRA™ plus film digitizer 63

VIDAR Film Digitizer Installation Guide

Loading a single film

1. Ensure the LED on the front of the digitizer is solid green.

2. Hold the film in front of you as you would view it on a light box.

Note:

If you load the film incorrectly, the digitized image may

be flipped or rotated.

3. Place the film into the slot BEHIND the

blue area.

The blue area is defined by a lip and a

groove on the top edge of the digitizer

where the feeder is attached. Place a

single film directly on the multi-film

behind the lip of the blue area.

When the SIERRA™ plus detects the

film, it stages the film—it pulls the film in

about 1" (2.5cm), then pushes the film

back out about 1/2" (1.25cm).

Note:

When a film has been staged, it is in the digitizer’s light

path. The ADC (Automatic Digitizer Calibration) feature requires

that the light path be clear of the film for proper background

calibration of the digitizer. The digitizer will automatically adjust

the film’s position to properly proceed with ADC. Depending on

the location of the film’s leading or trailing edge, and the length

of time the film has been blocking the light path, the film will be:

a) pushed up, b) pushed down, or c) ejected to remove the film

from the light path.

continued

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Keine Kommentare

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung Seite 65