Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung PDF herunterladen (Seite 35)

Wall mounting the SIERRA™ plus film digitizer 33

VIDAR Film Digitizer Installation Guide

1. Select proper wall space.

SAFETY WARNING

Attach the digitizer-mounting bracket to a permanent wall. Do

not attach the mounting bracket to a temporary wall, unsecured

wall or wall divider.

Consider the following points when selecting a location for the digitizer:



The digitizer requires a space that is at least:



46 inches (116.8cm) high.



24 inches (61.0cm) wide.



11 inches (27.9cm) deep.



The digitizer’s entrance tray extends above the mounting bracket, and

its exit tray extends below the mounting bracket. Carefully study the

diagram on the next page to ensure enough wall space is available—

above, below and to the sides.



The digitizer’s entrance tray accommodates films up to 17 inches

(43.2cm) high. A 17-inch film extends above the feed tray. This is

accounted for in the mounting space dimensions on the next page.



The digitizer can fit below an overhead cabinet, above a countertop,

or between an overhead cabinet and a countertop—as long as the

mounting dimensions shown on the next page are satisfied.



Locate the digitizer at an efficient working height. See step 2 in this

chapter for recommendations.



The digitizer must be within 10 feet (2.5m) of an electrical outlet.



Locate the digitizer away from traffic.

Note:

If suitable wall space cannot be found, you

must

mount

the digitizer on the table-top stand.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 85 86

Keine Kommentare

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung Seite 35