Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung PDF herunterladen (Seite 53)

Installing SCSI software for the SIERRA™ plus film digitizer 51

VIDAR Film Digitizer Installation Guide

Apply power: digitizer first, then PC

1. Ensure the PC is turned off.

Note:

Always apply power to the digitizer before turning on the

computer. This enables the computer to recognize the digitizer.

2. Connect the digitizer’s electrical power cord (connected to the power

supply) to an electrical outlet.

3. Turn on the digitizer. The on/off switch is located behind the upper

right corner.

4. Observe the LED on the front of the digitizer: the LED should flash

yellow for several minutes. This indicates the digitizer is performing

internal tests.

5. When the LED stops flashing and remains green, turn on the PC.

6. Go to the section in this chapter that matches your computer’s

operating system.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 85 86

Keine Kommentare

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung Seite 53