Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung PDF herunterladen (Seite 72)

Troubleshooting the SIERRA™ plus film digitizer 70

VIDAR Film Digitizer Installation Guide

Symptom Corrective action

Multi-film feed tray won’t feed films. The multi-film feed tray must be connected to the

digitizer with the multi-film feed tray cable. The cable is

located above the digitizer body, on the left side (when

viewed from the front). Ensure the cable is present.

Ensure one end of the cable is plugged into the jack on

the multi-film feed tray, and the other end is plugged

into the digitizer. After checking cable and connections,

restart digitizer, then restart PC after LED turns green.

After applying power, LED on front

keeps flashing yellow.

After power is applied, digitizer normally requires about

3.5 minutes to normalize and calibrate, during which

time the LED will flash yellow. If LED flashes yellow for

more than 5 minutes, reset digitizer or turn power off

and on again (both procedures described later in this

chapter).

LED remains dark, in spite of using

proper power-on procedure described

later in this chapter.

1. Ensure wall outlet is providing AC power: obtain

another electrical device known to be working, and

plug it into that AC wall outlet.



If other device doesn’t work, AC power is not

available at that wall outlet. Get help from

building services.



If other device does work, AC power is available

from that outlet. Go to step 2.

2. With power applied to digitizer, look into digitizer film

entrance slot. If you see light coming from inside

digitizer, power is on. For this condition (LED dark,

internal light on), get qualified technical help.

3. If you have another SIERRA film digitizer, try its

power supply.



If digitizer works with other power supply, original

power supply is defective. Obtain replacement

VIDAR SIERRA

power supply from your system

integration specialist.

Do not substitute any

other power supply.



If digitizer does not work with other power supply,

digitizer is defective. Get qualified technical help.

continued

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Installationsanleitung Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps